TransCore 05847 用户手册
This document describes the procedures to set up and use an Encompass 1150 (E1150) Mobile Reader.
Required Supplies
You need the following additional materials and/or tools to complete the reader installation:
•
Host PC using Windows (2000, XP, Vista, or 7) operating system with CD drive and at least one USB port
(either USB 1.0 or USB 2.0)
(either USB 1.0 or USB 2.0)
•
Field Configuration Software (FCSW) CDROM
•
USB communications cable provided with E1150
•
Battery charger with power cable provided with E1150
•
Test tag provided with E1150
Installing Field Configuration Software (FCSW)
Install the Field Configuration Software
Insert the FCSW CDROM into the host computer and follow the steps to load the software. The program installs a
shortcut icon for the software and a shortcut icon for the E1150 mobile reader instructions to the desktop.
shortcut icon for the software and a shortcut icon for the E1150 mobile reader instructions to the desktop.
CAUTION: Do not launch the field configuration software program at this time.
E1150 Setup
Note: The E1150 mobile reader is designed primarily for use in an office environment, but can be used outdoors in
a limited environment.
a limited environment.
1.
Place the E1150 on a flat surface.
2.
Plug the power cord from the E1150 battery charger into the Charger port at the base of the E1150. Plug the
power cord into a standard 110V AC wall outlet. Allow the E1150 to fully charge. The green LED indicator
located on the charger will illuminate when the unit is ready for use. The E1150 unit receives its charging via
the dedicated charger connected through the Charger port. The unit cannot be charged through the USB port.
power cord into a standard 110V AC wall outlet. Allow the E1150 to fully charge. The green LED indicator
located on the charger will illuminate when the unit is ready for use. The E1150 unit receives its charging via
the dedicated charger connected through the Charger port. The unit cannot be charged through the USB port.
Note: The automatic charger shutoff allows for the E1150 to remain connected to the charger after completion of a
charge cycle.
charge cycle.
3.
Connect the USB data cable from the USB port at the base of the E1150 to one of the host computer's USB
ports. Allow the device driver to be detected and installed automatically.
ports. Allow the device driver to be detected and installed automatically.
If the device driver fails to automatically load, disconnect the E1150 from the host computer. Locate the
device driver setup executable file on the root directory of the field configuration software CDROM:
CDM20828_Setup.exe, or go to
device driver setup executable file on the root directory of the field configuration software CDROM:
CDM20828_Setup.exe, or go to
to download
Encompass
®
1150
Mobile Reader
16-1150-002 REV A