Wulfsberg Electronics Division 2000-800 用户手册

Page 24 of 39 

Publication No. 150-049105 

P-2000 Operators Manual 

Rev. A 

Oct 2003 

Repeater mode is not a specific mode of the P-2000 but an airborne repeater can effectively created by 
preprogramming specific channels and then using the RELAY MODE.  It is also necessary for the two transceivers, 
FM1 and FM2 to use the same band.   In other words, you cannot perform a repeater function with a P-2000 that has 
FM1 operating in the 136-174 MHz band and FM2 operating in the 800 MHz band.  

Say a P-2000 channel normally uses a repeater that is not working and an area is without communications on that 
channel.  To act like an airborne repeater the operator must program a special preset channel with the receive and 
transmit frequencies reversed.  We suggest giving this channel a special ALPHA ID that helps the operator 
recognize it as a special repeater channel associated with the original channel.  To operate as an airborne repeater 
perform the following steps: 

•  While on the HOME PAGE set the ACTIVE channel to the channel you normally use the repeater on FM 1. 

•  Put FM1 in DIRECT MODE by pressing the DIR button. 

•  Select the special channel associated with the repeater on FM2. 

•  Go into the RELAY MODE. 

•  If the operator wants to talk select FM2. 

 

 

 

You can always get back to the HOME PAGE by pressing the HOME 
button one or more times.