Wulfsberg Electronics Division 2000-800 用户手册
P-2000/C-2000/RT-2000
Operator’s Manual
Page 31 of 39
Publication No. 150-049105
P-2000 Operators Manual
Rev. A
Oct 2003
CPS MODE
Loading Channel Memory
Programming the preset channels of the P-2000 must be performed with PC based program available from
MOTOROLA named CPS. Normally this procedure is accomplished by a technician familiar with this software
package since extensive knowledge is required to operate the Motorola software. As a note to the technician, no
RIB box is required between the PC and P-2000 since Wulfsberg has built this capability into its transceiver. The
process to read and modify the transceiver preset channels is as follows:
MOTOROLA named CPS. Normally this procedure is accomplished by a technician familiar with this software
package since extensive knowledge is required to operate the Motorola software. As a note to the technician, no
RIB box is required between the PC and P-2000 since Wulfsberg has built this capability into its transceiver. The
process to read and modify the transceiver preset channels is as follows:
• Ensure you are on the HOME PAGE.
• Press the PROG button. If prompted, enter the password #1 (In the system programming, the user has the
option of eliminating this password by setting it to “0000”). The PROGAM page will be displayed as below:
• Highlight the CPS option and press the enter button. The Transceiver Setup page will be displayed with the
CPS load already pre-selected as shown below:
• Select XCVR FM1 or FM2, highlight the start option and press enter to begin.