Wulfsberg Electronics Division 2000-800A 用户手册
P-2000/C-2000/RT-2000
OPERATOR’S MANUAL
Page 16 of 40
Publication No. 150-049105
Operator’s Manual
Rev. B
Dec 2004
Selecting a Channel by Alphanumeric Identifier
To change the standby channel using the alpha identifier, use the cursor knob to move the cursor square around the
alpha identifier as shown below. Turn the value knob until the channel is your desired channel. Notice that
channels change alphabetically.
alpha identifier as shown below. Turn the value knob until the channel is your desired channel. Notice that
channels change alphabetically.
Using the Direct/Repeat Feature
The P-2000 supports both direct and repeat modes of operation. Any preset channel that has identical transmit and
receive frequencies is considered a direct channel. If the transmit and receive frequencies are different, the P-2000
considers the channel a repeater channel. Repeater channels can be temporarily changed into direct channels by
pressing the DIR button. This will temporarily copy the receive frequency into the transmit frequency. The direct
mode indicator will light. The following illustration shows radio 1 in direct mode.
receive frequencies is considered a direct channel. If the transmit and receive frequencies are different, the P-2000
considers the channel a repeater channel. Repeater channels can be temporarily changed into direct channels by
pressing the DIR button. This will temporarily copy the receive frequency into the transmit frequency. The direct
mode indicator will light. The following illustration shows radio 1 in direct mode.
It can take several seconds for the direct operation to be completed once the button has been
pressed.
pressed.
Direct Mode Indicator
NOTE: