Wulfsberg Electronics Division 2000-UHF1 用户手册
Wulfsberg Electronics
P-2000 and C-2000/RT-2000 Operator’s Manual
Document 150-041102 Revision A
Page 37 of 37
Steps to Successful Setup and Operation
While we would like to pull products out of the box and immediately start to use them, this system is one that takes
just little work to get to that point. First READ THE OPERATORS MANUAL!!! This will familiarize you with
the buttons and display pages of the system. The following checklist will help installers setup the P-2000 or
C-2000/RT-2000.
just little work to get to that point. First READ THE OPERATORS MANUAL!!! This will familiarize you with
the buttons and display pages of the system. The following checklist will help installers setup the P-2000 or
C-2000/RT-2000.
1. Note all part numbers of components in your system..
P-2000 Part Number =
_______________________________________
C-2000 Part Number =
_______________________________________
RT-2000 Part Number = _______________________________________
Please write down the frequency bands of the transceivers inside the P-2000/RT-2000.
FM #1 = ___________________
FM #2 = ___________________
2. Using the SYSTEM Programming page 2, select whether the unit will be operated in Mode 1(only one
mic/headset port) or Mode 2 (two independent mic/headset ports). Review the other options and configure as
desired. Return to the HOME page.
desired. Return to the HOME page.
3. Put the P-2000/RT-2000 in CPS mode for FM #1.
4. Connect a PC to the programming port of the P-2000/RT-2000 and run the Motorola CPS software.
5. Using the CPS software, read the codeplug of FM #1. Save this first in case you need to return to factory
settings.
6. Program personalities and Zones/Channels. It is very important to use good channel identifiers so operators can
efficiently determine the purpose of the channel. Whenever possible, use the same channel name the ground
units use so that when calling out channel changes both the aircraft and the ground units can use the same
channel names. These steps require significant knowledge of the Motorola software. We encourage enlisting
the help of someone familiar with Motorola CPS software to successfully program the internal transceivers.
units use so that when calling out channel changes both the aircraft and the ground units can use the same
channel names. These steps require significant knowledge of the Motorola software. We encourage enlisting
the help of someone familiar with Motorola CPS software to successfully program the internal transceivers.
7. Save the modified codeplug on the hard drive and then download it into FM1.
8. Do the above for FM #2 if applicable.
9. Upon the exit from CPS mode, the P-2000/RT-2000 will automatically go into “LEARN” mode. At this time
the unit is interrogating the internal transceiver modules for information about channels that were programmed
during CPS operations. Wait until the display indicates successful completion of this process.
during CPS operations. Wait until the display indicates successful completion of this process.
10. Validate that all channels programmed during CPS are now functional on both FM #1 and FM #2 transceivers.