Wulfsberg Electronics Division CVC-151 用户手册

 

Page 28 

Publication No. 150-047012 

Dec 2005 

Rev. D 

1.  Set the MODE SELECTOR to ON. 

2.  If these are not the desired frequencies, rotate the FREQUENCY KNOBS until the desired frequency is 

displayed on the bottom portion of the display 

3.  Press and release the FREQUENCY TRANSFER button.  This exchanges the two displayed 

frequencies.  The desired frequency is now active and may be used immediately. 

4.  Adjust the VOLUME CONTROL for the desired audio level. 

5.  Rotate the FREQUENCY KNOBS until the desired standby frequency appears on the bottom portion of 

the display. 

NOTE:  To tune the active frequency only (without first tuning the standby and then "flipping" the 

frequencies), press and hold the FREQUENCY TRANSFER button for two seconds, then 
release it.  This temporarily removes the standby frequency from the display.   

Now the FREQUENCY KNOBS may be used to change the active frequency.  The active 
frequency may be used immediately.   

To restore the standby frequency to the display, press and hold the FREQUENCY TRANSFER 
button two seconds.