Everspring Industry Co Ltd CA212 用户手册

1 

 

Installation and Operating Manual 

Introduction 

 
The Solar Camera is designed to economically provide safety, 
security, convenience to your home and business. Its solar 
panel collects daylight and maintains a charge to the battery of 
the camera during daylight hours. A negligible amount of 
energy is released by the rechargeable battery to operate the 
camera during nighttime.     
 
The components included in the C128W Solar Camera Kit: 

● 

1 x Solar Camera with PIR and Solar Panel (Transmitter) 

● 

1 x Audio & Video Receiver 

● 

1 x Power Adapter for Receiver 

● 

1 x 3 Feet RCA/SCRT Cable 

●

  1 x 6V 1.2A Rechargeable Battery 

●

  1 x 9V Alkaline Battery 

● 

1 x Waterproof Rubber Plug 

●

  1 X Remote Control

 

 
Caution 

 
Pay attention to the following before you install: 
1. Sufficient daylight: Solar panel 
requires constant charge during 
daylight hours. Please mount the 
camera at the location that can 
receive sufficient daylight exposure. 
 
2. Detecting sensitivity: A passive 
infrared sensor 
operates by detecting 
the objective 
movement and heat. 
When the temperature 
of the moving object 
and its surrounding 
area are close in value, it may reduce 
PIR’s sensitivity. The motion detector’s 
infrared beams radiate outward like the slat of a wooden fence. 
Prior to mounting, keep in mind that the motion sensor is more 
sensitive to the motion that crosses these “slats”, and less 
sensitive to the motion that moves directly towards the sensor 
(see Figure 1 and 2.) 
 
3.Keep a light source during nighttime: The camera cannot 
work in total darkness. Please bear in mind the camera's 
viewing area must be illuminated with a suitable light source 
during nighttime. 
 

Installation 

 

a. 

Use the fixing template provided to mark the position of the 
four fixing holes. Drill four 5mm-diameter holes.   

b. 

Mount backplate by inserting two screws into fixing holes on 
the top edge of backplate. (All electronic components are 
housed within the backplate.) 

c. 

Adjust the “DWELL_SW(SW3)” knob on backplate to set up 
transmission time (lock time) of images and voices. It can be 
set as 10,20,30 or 40 seconds. 

d. 

Adjust the “CH_SW” knob on backplate to set up a channel. 
And remember which channel you selected.   

e. 

Plug the camera’s 12 Pin plug (Cable) into socket on the 
backplate, then secure the camera set (front cover) to the 
backplate by inserting screws into two fixing holes on the 
button edge of front cover and backplate. And then insert 
the waterproof rubber plug into the hole at the bottom of 
front cover.

 

f. 

The camera and PIR which under the main solar panel 
cabinet can be swiveled upward to 5°, downward to 
45°(refer to Figure 4) and 90° horizontally (refer to Figure 5) 

g. 

Adjust the camera and PIR angle according to your need. 

Waterproof Rubber Plug