Everspring Industry Co Ltd HSM02 用户手册

1 

 
The Door/Window Detector is a Z-Wave

TM

 enabled device and is fully compatible 

with any Z-Wave

TM

 enabled network. Z-Wave

TM

 enabled devices displaying the 

Z-Wave

TM

 logo can also be used with it regardless of the manufacturer, and ours 

can also be used in other manufacturer’s Z-Wave

TM

 enabled networks.  Inclusion 

of this Door/Window Detector on other manufacturer’s Wireless Controller menu 
allows remote turn-on of connected modules and their connected lighting when the 
Detector is triggered. 

LED

TEMPER
SWITCH

BATTERY

BATTERY

MYLAR

FIXED

SCREW

 

 

 
In the front casing, there is a tamper switch which is used to carry out inclusion, 
exclusion or reset.  When power is first applied, its LED flashes on and off 
alternately and repeatedly at 2-second intervals.  It implies that it has not been 
assigned a node ID and cannot work with Z-Wave enabled devices.    Please get 
familiar with the terms below before starting the operations.     
 

Inclusion   

Add a Z-Wave enabled device (e.g. Detector) to Z-Wave network. 

Exclusion   

Delete a Z-Wave enabled device (e.g. Detector) from the network. 

Association    After inclusion, you have to define the relationship between devices. 

Trough association, device can be assigned as master/slave, and specify 
which slave is going to be controlled by which master. 

Reset 

Restore Detector to factory default. 

 
The table below lists an operation summary of basic Z-Wave functions.  Please 
refer to the instructions for your Z-Wave

TM

 Certificated Primary Controller to access 

the setup function, and to include/exclude/associate devices.   

No node ID 

The Z-Wave Controller does not allocate 
a node ID to the unit. 

2-second on, 2-second 
off 

Inclusion 

1.  Have Z-Wave Controller entered 

inclusion mode. 

 

2.    Pressing tamper switch three times 

within 1.5 second will enter inclusion 
mode. 

Exclusion 

1.  Have Z-Wave Controller entered 

exclusion mode. 

LED lights up once 
whenever tamper switch 
is pressed once. 

2.  Pressing tamper switch three times 

within 1.5 second will enter 
exclusion mode. 

Reset 

1.  Press tamper switch three times 

within 1.5 second. 

 

2.  Within 1 second, press and hold the 

tamper switch until LED is off. 

LED keeps on before 
reset function has been 
completed. 

3.  IDs are excluded and all of preset 

value will be reset to factory default.

2-second on, 2-second 
off 

Association 

1.    Have Z-Wave Controller entered 

association mode. 

 

2.    When pressing tamper switch three 

times within 1.5 second, the unit will 
emit the NIF which implies that the 
unit has entered association mode. 

 

Ú

Including a node ID allocated by Z-Wave Controller means inclusion.    Excluding a node 
ID allocated by Z-Wave Controller means exclusion. 

Ú

Failed or success in including/excluding the node ID can be viewed from the Z-Wave 

Controller.