Welite Corporation Limited LMT1008 用户手册
BATTERY EXCHANGE:
3V CR2032 lithium battery is included ex-factory.
When battery voltage is low, transmission is low.
Slide down the battery cover and replace a fresh new battery.
SPECIFICATION:
LMT-1008 Transmitter:
3V CR2032 BATTERY included
LMR-404 Receiver:
Frequency: 433.92MHz
Input: DC 12V
Attention: please make sure that LED DC Power Supply has short-circuit / overload protection function, before electrical
connection.
Output: 3A Max.
R.G.B. Output: DC 12V 1.5A max. / each.
Ta: 50 ℃
Tc: 80℃
FAULT FINDING:
No activation: Check battery polarity or running out battery
LMT-1008 Transmitter:
3V CR2032 BATTERY included
LMR-404 Receiver:
Frequency: 433.92MHz
Input: DC 12V
Attention: please make sure that LED DC Power Supply has short-circuit / overload protection function, before electrical
connection.
Output: 3A Max.
R.G.B. Output: DC 12V 1.5A max. / each.
Ta: 50 ℃
Tc: 80℃
FAULT FINDING:
No activation: Check battery polarity or running out battery
Check code link successful.
Check if memory setting is full
Check correct wiring installation.
Check correct wiring installation.
Warning!
DO NOT OVERLOAD
Disconnect main power before wiring installation.
Do not use in damp places like patios, cellar, flammable liquid, solvents, paints etc..
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
DO NOT OVERLOAD
Disconnect main power before wiring installation.
Do not use in damp places like patios, cellar, flammable liquid, solvents, paints etc..
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.