DTC Communications Inc. PDTX1000S 用户手册
DTC COMMUNICATIONS, INC.
7
OPERATION
Using your Palladium Transmitter
Follow the instructions given in the Quick Start section on pages 4-5.
When power is first applied to the Palladium, the unit reverts to the last
used channel and RF status. One of the green channel LEDs will turn ON
indicating the active channel. The Alarm LED may be ON, which indicates
that there is no active video input.
When power is first applied to the Palladium, the unit reverts to the last
used channel and RF status. One of the green channel LEDs will turn ON
indicating the active channel. The Alarm LED may be ON, which indicates
that there is no active video input.
Changing your Transmitter Configuration
The Palladium Transmitter can store up to 8 different configurations,
which can be selected on the front panel. Each of these configurations can
be programmed into the Transmitter with the supplied DTC Programming
Software and a Windows PC. Refer to the Programming section on page 10
for more information.
which can be selected on the front panel. Each of these configurations can
be programmed into the Transmitter with the supplied DTC Programming
Software and a Windows PC. Refer to the Programming section on page 10
for more information.
To cycle through your preconfigured channels press the CONFIG button
once to advance to the next setting. By default, the Palladium will turn
OFF the transmitted signal while
you are changing channels. This is
to prevent accidental interference.
Push the RF button after channel
selection to resume RF
transmission of your video image.
once to advance to the next setting. By default, the Palladium will turn
OFF the transmitted signal while
you are changing channels. This is
to prevent accidental interference.
Push the RF button after channel
selection to resume RF
transmission of your video image.
Palladium Pd-TX-2000
2 Watt Digital Transmitter