DTC Communications Inc. T2500 用户手册

NOTE:  Do not operate the transmitter without an antenna installed.

 

NOTE:  The channel being used must be programmed 

        

to use the internal or 36” external mic by  

        

selecting Audio Input in Edit Channel Settings (see page 22).

1  Install the 36” remote microphone into the 5-pin locking connector on  

 

the transmitter. Observe the alignment mark for the large pin.

2  Install the noodle antenna into the antenna connector. 

NOTE: This is a push-on, push off locking connector. Use extreme 

caution when connecting or removing the connector. 
(See illustration, left.)

 

3  Using a small screwdriver, turn the recessed rotary switch located on  

 

the back cover to the desired channel.

4  Attach/install fresh batteries into the battery pack, being careful to  

 

observe proper polarity. The unit auto-powers ON.

OFF/ON

STATUS

6

4

8

0

2

Programming Cable

P25 Micro

Line up longest pin with dot.

Alignment Mark for Large Pin of

5-pin Locking Connector