Tatung Company AWD209T 用户手册

t

rouBleSHootInG

11

•    Confirm that the headphones are turned on (the LED is blue) and tuned to the 

transmitter. If the LED on the right headphone is flashing blue, the headphones 
are not tuned to the transmitter. Press the link key on the headphones and on the 
transmitter’s back panel to tune the headphones.

•    Check that the headphone volume is turned up.
•    If you’re using a variable output audio source (like a headphone jack or variable 

output on a TV set), make sure the source component’s volume is set high enough 
for the transmitter to detect. 

•    If you are using a Tape 2 Monitor output from your receiver/amp as the audio output, 

check that you have pressed the Tape Monitor/Tape 2 button on the front of the 
receiver. This will turn on the Tape 2 outputs, which may not have been active.

Interrupted sound
•    Move closer to the transmitter with the headphones on. Sending the signal 

through certain materials, such as glass, tile, and metal, can decrease the effective 
transmitting distance of the system.

•    Make sure the headphones are charged and that the transmitter is properly 

connected to the audio source. Then, move the headphones close to the transmitter 
and press the headphone power button again.

•    Check the LED on the right headphone. If it’s blinking, you’ve lost the transmitter’s 

signal. Move closer to the transmitter. If you don’t see the LED, the headphones’ 
rechargeable battery needs to be recharged. Use the AC adapter to recharge the 
headphones.