HARRIS CORPORATION MBS800B075 用户手册

MM102225V1, Rev. B 

Objective: The Cisco 3600 provides comprehensive monitoring capabilities for the T1 
port that carries data traffic over the communications backbone. The showcontroller 
command accumulates statistics over sixteen 15-minute intervals. This test does not form 
part of the site acceptance testing but is included as a diagnostic tool to aid resolution of 
link related issues. 

1. 

Allow the Unit to operate with the T1 
connected for at least 5 minutes. 

 

2. 

Using a PC connected to the Cisco 
CONSOLE port, enter the following 
command from the enabled prompt: 

buck40sas# show contr t1 1/0 [CR]

21

 

The 3600 will respond with the Status 
Information on the right. 

T1 1/0 is up 

Applique type is Channelized T1 

Cable length is long gain36 0db 

No alarms detected 

Framing is ESF, Line Code is B8ZS, Clock 
Source is Line 

Data in current interval (741 seconds 
elapsed): 

0 Line Code Violations, 0 Path Code 
Violations 

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 
0 Degraded Mins 

0 Errored Secs, 0 Bursty Err Secs, 0 
Severely Err Secs, 0 Unavail Secs 

Data in Interval 1: 

0 Line Code Violations, 0 Path Code 
Violations 

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 
0 Degraded Mins 

0 Errored Secs, 0 Bursty Err Secs, 0 
Severely Err Secs, 0 Unavail Secs 

Data in Interval 2: 

0 Line Code Violations, 0 Path Code 
Violations 

0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 
0 Degraded Mins 

0 Errored Secs, 0 Bursty Err Secs, 0 
Severely Err Secs, 0 Unavail Secs 

                                                           

21

 "Buck40", where used in this manual, is only an example of the applicable code.