HARRIS CORPORATION MBS800B075 用户手册

MM102225V1, Rev. B

NAME OF TOOL

USE/COMMENTS

Soft Jaw Connector Pliers

Tightening or loosening N-type connectors

Crescent Pliers: M/A-COM Part Number 529-10 or Tessco Part
Number 83040

Superflex Antenna Cable

To convey antenna signals to equipment racks within a shelter

Torque Wrench

Tightening SMA connectors

Preset to 5/16-inch, 8 inch-pounds of torque: M/A-COM Part
Number 1055419-1 (2098-5065-54) or Tessco Part Number
14682, 1 Newton/Meter torque

Trash Bags

For removal of debris from site

Hammer Drill, ½” chuck

Used to drill holes for anchors in concrete floor

Set tool

Used to expand anchors in the floor

Basic hammer

Used with set tool to expand anchors in the floor

Crimpers

Used to crimp on lugs to ground wire and power leads

Greenlee Knock-Out tool

Used to punch out hole on top of rack for entry of ground wire

9/16” Socket

Used to secure rack to the floor and power leads to bus bar on
rack

½” Socket

Used to secure ground to bus bar

7/16” Socket

Used to bolt racks together

Tape measure

Used to measure proper distance from wall to rack

Soldering gun

Used to solder leads of control cable connector

Heat gun

For shrink tubing with control cable connector

12” wire ties

¾” anchors (tapcon)

1” bolts

Crimp on 1 hole lugs

Crimp on 2 hole lugs

T1 Crimper

AMP Hand Tool, Part Number 2-231652-0

Labeling System for field
use

Recommended unit: P-Touch Labeling System, Model PT-330

Insulating washers

Between floor and bottom of rack between anchor bolts and
rack

Service Monitor

HP 8920

Network Analyzer

HP 8752C (Used in conjunction with HP 8920 for Tower Top
Amplifier)