Digital Monitoring Products Inc PC0088 用户手册

Note:  You must remove all batteries to reset the low battery signal before installing new batteries.  Always replace 

all three batteries.  Allow three minutes after installing the batteries for the sensor to become operational before 

initiating a Walk Test.
Use only 3V lithium CR-123A batteries.  Use the following steps to install the batteries:

1. Remove the unit from the wall mounting bracket.  See Mounting the Unit.
2. Remove all batteries (if installed) before installing new batteries.
3. Observe polarity and insert the three lithium batteries into the battery holder where indicated in Figure 6. 

  Caution: Risk of fire, explosion, and burns.  Do not  recharge, disassemble, heat above 212°F (100°C), or

 

incinerate.  Properly dispose of unused batteries.

Tamper

Opening Tab

Battery 

Compartment

Switches

Switch Settings

33'

(10.1m)

50'

(15.2m)

STD

BI

Refer to the panel programming guide as needed.  Program the device as a zone in 

Zone Information during panel 

programming.  Typically select the Night or Exit zone type for the 1125 PIR.  At the Serial Number: prompt, enter the 

serial number recorded from the back of the device case.  Continue to program the zone as directed in the panel 

programming guide.  
Note:  When a receiver is installed or powered down and powered up or the panel is reset, the supervision timer 

cycle restarts.
Note: You can re-use a device in another system after the serial number has been previously programmed.  Remove 

the device battery, press and hold the tamper switch for one second to clear the panel house code from the device 

memory and set the device back to factory defaults.