Rhine Electronics Co Ltd 7078T 用户手册
Press firmly below arrow and slide battery cover off .
2. Slide code switches to your choice of UP and DOWN position .
3. Factory setting is all UP . Do not use this setting .
4. Use ball point pen or small screwdriver .
5. Slide firmly up or down .
3. Factory setting is all UP . Do not use this setting .
4. Use ball point pen or small screwdriver .
5. Slide firmly up or down .
B. Setting the code on your new Receiver unit .
1. Slide code switches to the same positions as set on your transmitter .They must be set to same
positions to work .
2. Replace battery cover on transmitter .
NOTICE :
The changes or modifications not expressly approved by the
party responsible for compliance could void user’s authority
to operate the equipment .
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATIONS IS
SUBJECT INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFEERENCE THAT MAY CAUSE
UNDESRIED OPERATION.
to operate the equipment .
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATIONS IS
SUBJECT INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFEERENCE THAT MAY CAUSE
UNDESRIED OPERATION.
Page : 2-2