Rhine Electronics Co Ltd 7235T 用户手册
INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED
CONTROLLER
CONTROLLER
1. Setting the code on your new transmitter .
Within 60 seconds of turning the AC power on, press and hole the FAN ON/OFF
button for 5 seconds. The receiver will then lock in the chosen frequency.
If your fan has a light it it will blink twice, for fans without lights check operation using the
transmitter
If your fan has a light it it will blink twice, for fans without lights check operation using the
transmitter
NOTICE :
The changes or modifications not expressly approved by the
party responsible for compliance could void user’s authority
to operate the equipment .
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no
change to the antenna or the device is permitted. Any change to the antenna or the device
could result in the device exceeding the RF exposure requirements and void user’s authority to
operate the device.
change to the antenna or the device is permitted. Any change to the antenna or the device
could result in the device exceeding the RF exposure requirements and void user’s authority to
operate the device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may cause
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may cause
3