Rhine Electronics Co Ltd 9787T 用户手册
2/2
2. Setting the code on your new transmitter .
Within 60 seconds of turning the AC power on, press and hole the OFF/STOP button for 5
seconds. The receiver will then lock in the chosen frequency. If your fan has a light it it will blink
twice, for fans without lights check operation using the transmitter
twice, for fans without lights check operation using the transmitter
3.CONNECTING THE TRANSMITTER
1.Remove wall plate, disconnect and remove the toggle
switch from wall junction box. Using the wire nuts
provided, make the electrical connections to the new
Transmitter unit as shown in figure 2.
2.If your outlet box has a ground wire (green or bare
copper)connect the wall transmitter’s ground wire to it;
otherwise connect the wall transmitter’s ground wire directly to one
of the screws from the outlet box.
switch from wall junction box. Using the wire nuts
provided, make the electrical connections to the new
Transmitter unit as shown in figure 2.
2.If your outlet box has a ground wire (green or bare
copper)connect the wall transmitter’s ground wire to it;
otherwise connect the wall transmitter’s ground wire directly to one
of the screws from the outlet box.
3.Carefully tuck wire connections inside wall switch box.
Secure Transmitter with the two screws (provided). Attach
wall plate over control unit with the 2 screws previously
removed(FIG 3)
NOTICE :
The changes or modifications not expressly approved by the party
responsible for compliance could void user’s authority to operate the equipment .
This device complies with part 15 of the FCC Rules. Operations is subject to the
following two conditions: (1)this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
following two conditions: (1)this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that