Rockford Corporation FS90RX915 用户手册
24
PROGRAMMABLE OPTIONS
You can program multiple options in one session if you start with the lowest option and continue on to higher options
without repeating steps #1-3 below. For example, you can follow the programming steps to change an Option by
pressing button 1 to 4 on the remote, then you can continue pressing the program button additional times to get to a
high number option and change the setting without having to repeat Steps 1-5. You can only go from low to higher
option numbers in one session.
without repeating steps #1-3 below. For example, you can follow the programming steps to change an Option by
pressing button 1 to 4 on the remote, then you can continue pressing the program button additional times to get to a
high number option and change the setting without having to repeat Steps 1-5. You can only go from low to higher
option numbers in one session.
To Engage Option Programming:
1. Turn Ignition Key to the ON position
2. Press Program / Valet button 5 times, after a few seconds the unit will flash the lights and Siren Chirps 5 times.
3. Push the valet/program button [again] the number of times that corresponds to the option number desired (1 thru
28). You must get a light flash and chirp after each button press.
4. When you reach the desired programming level, Press button #1, #2 #3 or #4 to change the option level. The
siren and horn will confirm with 1-4 chirps. The remote control will confirm program option selection on top
right corner of display. Example option #6 button 4 shows *06--4
right corner of display. Example option #6 button 4 shows *06--4
5. Turn Ignition OFF and check for changed features.
Note: The Program Mode Exits automatically after 20 seconds (lights flash 4 times on exit).
Note: The Program Mode Exits automatically after 20 seconds (lights flash 4 times on exit).