Japan Radio Co Ltd. NJJ-200 用户手册
HX0BD14031(1/1)
6.24.2014
Japan Radio Co.,
Symptom: Sensor ID does not show up in the sensor select screen of [Sensor select] menu
The symptom happens when wireless LAN is not established between Smartphone and the
sensor unit. The three possible causes and solutions are listed below.
Cause 1: The sensor select screen was selected before establishing wireless LAN
communication after turning on.
Solution: Wait two or three minutes and see if the sensor ID appears in the sensor select
screen.
Cause 2: The sensor unit is turned off.
Solution: Confirm that the sensor unit’s Power LED turns on in red. If the Power LED
turned off, check if the charged battery pack is installed and the sensor unit is switched to
N position.
in 3 m near by the sensor unit, then check if the sensor ID appears in
ensor select screen.
tphone and the sensor unit. And please send back Smartphone and
e sensor unit to us.
O
Cause 3: The distance between Smartphone and the sensor unit exceeds 3 m.
Solution: Confirm that the distance does not exceed 3 m. If the distance exceeded 3 m,
move Smartphone with
s
If any solutions above did not solve the symptom, it may be caused by the failure of
Smartphone or the sensor unit. In this case, please let us know the status, then we will send
the substitute of Smar
th
Cause 3: The distance between Smartphone and the sensor unit exceeds 3 m.
Solution: Confirm that the distance does not exceed 3 m. If the distance exceeded 3 m,
move Smartphone with
s
If any solutions above did not solve the symptom, it may be caused by the failure of
Smartphone or the sensor unit. In this case, please let us know the status, then we will send
the substitute of Smar
th