Rothenbuhler Engineering Company Inc 1100-5 用户手册
Talkie Tooter 1100 User Manual
11
ACME 3 SPEED SLACKPULLER
The transmitter is worn around the waist using the attached belt. To operate the
transmitter it must be tilted so the antenna end is pointing up. The transmitter has two
push buttons. The button closest to the antenna is the UP or TOP button. The other
button is the DOWN or BOTTOM button. Send a signal by pressing either button for at
least 1/10 of a second, but less than 1 second.
transmitter it must be tilted so the antenna end is pointing up. The transmitter has two
push buttons. The button closest to the antenna is the UP or TOP button. The other
button is the DOWN or BOTTOM button. Send a signal by pressing either button for at
least 1/10 of a second, but less than 1 second.
TOP BUTTON
TOGGLE SLACKPULLER SLOW / STOP / CLOSE SKYLINE CLAMP
TOGGLE SLACKPULLER MEDIUM
PULSE SLACKPULLER MEDIUM IF SLACK IS OFF AND SKIDLINE IS OPEN
SLACKPULLER SLOW IF SLACKPULLER FAST ON
TOGGLE SLACKPULLER FAST
PULSE SLACKPULLER FAST IF SLACK IS OFF AND SKIDLINE IS OPEN
TOGGLE SLACKPULLER MEDIUM
PULSE SLACKPULLER MEDIUM IF SLACK IS OFF AND SKIDLINE IS OPEN
SLACKPULLER SLOW IF SLACKPULLER FAST ON
TOGGLE SLACKPULLER FAST
PULSE SLACKPULLER FAST IF SLACK IS OFF AND SKIDLINE IS OPEN
YARD/HAUL
START ENGINE
BOTTOM BUTTON
STOP
CLOSE SKIDLINE CLAMP IF BOTH CLAMPS ARE OPEN
OPEN SKIDLINE CLAMP IF ALL OUTPUTS ARE OFF
CLOSE SKYLINE CLAMP IF BOTH CLAMPS ARE OPEN
CLOSE SKIDLINE CLAMP IF BOTH CLAMPS ARE OPEN
OPEN SKIDLINE CLAMP IF ALL OUTPUTS ARE OFF
CLOSE SKYLINE CLAMP IF BOTH CLAMPS ARE OPEN
TOGGLE SKIDLINE CLAMP
TOGGLE SKYLINE CLAMP
OPEN SKYLINE CLAMP
OPEN SKIDLINE IF SKYLINE CLAMP OPEN
KILL ENGINE ACME – VER. 6
OPEN SKIDLINE IF SKYLINE CLAMP OPEN
KILL ENGINE ACME – VER. 6
Is a quick (1/4 of a second) press and release of the button.
Is three times as long as a .
Transmitter antenna must be pointed up to send signal!
Transmitter antenna must be pointed up to send signal!
DISCONNECT RADIO WHEN JUMP STARTING OR WELDING ON MACHINE.
CAUTION!!
WIRING INFORMATION FOR THE YARDER TRANSMITTER
CONNECTING WIRES INCORRECTLY WILL CAUSE DAMAGE TO TRANSMITTER
•
24 Volt System: Connect the white wire ONLY to 24 volts and the black wire to battery
ground.
ground.
•
12 Volt System: Connect the red wire ONLY to 12 volts and the black wire to battery ground.
•
Note: Green wire is not used.