Rothenbuhler Engineering Company Inc 1669-21 用户手册
1669-R RFD OPERATOR MANUAL REV. PP1
28
4. PRE-OPERATIONAL PROCEDURES.
4.1. PHYSICAL
INSPECTION.
4.1.1.
Inspect all components for physical damage.
CAUTION
Do not use any component that is damaged, suspected of being
damaged, or is not able to operate as designed. The safety of the operation could be
compromised.
compromised.
4.1.2.
Ensure the antenna / battery charger connector on the Controller Unit and
Remote Unit is not Damaged.
4.1.3.
Remove the antenna / battery charger connector dust cover and ensure the
electrical pin area is clean and free of foreign material. Replace the dust cover.
4.1.4.
Ensure the Antenna Assembly whip is not broken and that the whip has not
separated from the sealing compound at the top of the connector.
4.1.5.
Ensure that the spring-loaded binding posts on the Remote Units are not
damaged.
4.1.6.
Remove the red dust cover from the Antenna Assembly and ensure that there
is no foreign material in the electrical contact area. Replace the red dust cover.
4.2. BATTERY
CHARGING.
4.2.1.
The battery packs in the Controller Unit and Remote Units contain
rechargeable NiMH batteries. The battery packs are recharged through the antenna /
battery charger connector on each unit. Battery packs are not to be removed (case
opened) in the field.
battery charger connector on each unit. Battery packs are not to be removed (case
opened) in the field.
4.2.2.
The battery pack in the Controller Unit and Remote Units should be charged
before the system is used each time. The Battery Charger Assembly will charge the
Controller Unit and Remote Units in 100 minutes typically. Each Battery Charger
Assembly has nine independent rapid chargers. Each rapid charger has a CHARGE,
DONE, and DISCHG light. The Battery Charger Assembly has a single “BATTERY
DISCHARGE” switch. The Battery Charger Assembly will discharge all battery packs
connected, when the “BATTERY DISCHARGE” switch is pressed. Complete discharge
of battery packs occurs in approximately 3 hours. Battery capacity will be maintained if
the battery packs are discharged prior to charging.
Controller Unit and Remote Units in 100 minutes typically. Each Battery Charger
Assembly has nine independent rapid chargers. Each rapid charger has a CHARGE,
DONE, and DISCHG light. The Battery Charger Assembly has a single “BATTERY
DISCHARGE” switch. The Battery Charger Assembly will discharge all battery packs
connected, when the “BATTERY DISCHARGE” switch is pressed. Complete discharge
of battery packs occurs in approximately 3 hours. Battery capacity will be maintained if
the battery packs are discharged prior to charging.
4.2.3.
Turn off the power switch on the Battery Charger Assembly.