Shure AD2G55 用户手册

Certifications

Meets essential requirements of the following European Directives: 

• R&TTE Directive 99/5/EC

• WEEE Directive 2002/96/EC, as amended by 2008/34/EC
• RoHS Directive 2002/95/EC, as amended by 2008/35/EC

Note: Please follow your regional recycling scheme for batteries and electronic waste

Meets requirements of the following standards: EN 300 328, EN 300 422 Parts 1 and 2, EN 301 489 Parts 1 and 9, EN60065. 
Certified under FCC Part 15 and FCC Part 74. 
Certified in Canada by IC to RSS-123 and RSS-210. 
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/NMB-3(B)
 This radio transmitter has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and re-

quired antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated 

for that type, are strictly prohibited for use with this device. 
FCC ID:  DD4AD2A, DD4AD2B, DD4AD2C, DD4AD2D. IC:  616A-AD2A, 616A-AD2C, 616A-AD2D. 
This device complies with Industry Canada licence-exempt RSS standard(s). Operation of this device is subject to the following two conditions: (1) this de-

vice may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. 

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux 

conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même 

si le brouillage est susceptible d'en compromettre le fonctionnement. 
The CE Declaration of Conformity can be obtained from Shure Incorporated or any of its European representatives. For contact information please visit 

www.shure.com 
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/compliance

Authorized European representative:

Shure Europe GmbH

Headquarters Europe, Middle East & Africa

Department: EMEA Approval

Jakob-Dieffenbacher-Str. 12

75031 Eppingen, Germany

Phone: 49-7262-92 49 0

Fax: 49-7262-92 49 11 4

Email: info@shure.de

Licensing: A ministerial license to operate this equipment may be required in certain areas. Consult your national authority for possible requirements. 

Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate the equipment. Licensing of Shure wireless mi-

crophone equipment is the user’s responsibility, and licensability depends on the user’s classification and application, and on the selected frequency. Shure 

strongly urges the user to contact the appropriate telecommunications authority concerning proper licensing, and before choosing and ordering frequencies. 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep-

tion, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following 

measures: 

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device operates under an ACMA class licence and must comply with all the conditions of that licence including operating frequencies. Before 31 

December 2014, this device will comply if it is operated in the 520-820 MHz frequency band. WARNING: After 31 December 2014, in order to comply, this 

device must not be operated in the 694-820 MHz band.

Certified under FCC Part 74. 
Certified by IC in Canada under RSS-123 and RSS-102. 
IC:  616A-AD2 G50, 616A-AD2 H50, 616A-AD2 J50, 616A-AD2 L50.
FCC:  DD4AD2G50, DD4AD2H50, DD4AD2J50, DD4AD2L50. 

DRAFT 

9.8.16