Intermatic H0004 用户手册

下载
页码 3
-------------------------------------- DRAFT COPY --------------------------------------
Instructions for Model HA04 – Outdoor Module – using the HA09 Controller
<Front cover>
User’s Manual
*Illustration of HA04 Outdoor Module*
 <Inside cover>
General Description
Federal Communications Commission Statement
This device complies with part 15 of the FCC rules. Operation of this device is subject to 
the following two conditions:  (1) This device may not cause harmful interference, and 
(2) This device must accept any interference, including interference that may cause 
undesired operation.
NOTE:  This equipment has been tested and found to comply with the limits for a Class 
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference to 
radio communications. However, there is no guarantee that interference will not occur in 
a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following 
measures:
-- Reorient or relocate the receiving antenna or device.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
WARNING!
Changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate the equipment.
Enclosed you will find:
1 Corded Outdoor Module (for use with HA07, HA09, or any Z-wave enabled remote 
controller)
Installation Instructions
Corded Outdoor Module:
1. Plug the Outdoor Module into a powered, 125VAC outlet.
2. Plug the device you wish to control into the Outdoor Module receptacle. 
Maximum rating of the device should not exceed 1000 Watts (8.3A) Tungsten 
or 1800 Watts (15A) Resistive.
Remote Controller