Echostar Technologies LLC FSK03 用户手册

4. Use the number buttons to enter any number 

from 1 to 16. The SAT mode button goes out after you enter 
each digit, and then lights up again.

Write down the number you entered: 

5. Press the POUND (#) button.

If you entered the address correctly, the SAT mode 
button will flash three times.

6. Press the RECORD button. If you are using a 6.0 

remote with the green 1 key (no UHF Pro marking), 
you must point the remote control at the receiver 
while pressing the RECORD button.

7. Make sure the System Information screen shows the correct 

remote address as follows:

• If only one Remote Address is shown, make sure this 

address matches the number you entered in step 5. 

• If you are using 6.0 remote with the green 1 UHF Pro key, 

make sure that the Primary Remote Address shows 

 

UHF Pro and IR and that this address matches the number 
you entered in step 4.

• If you are using 6.0 remote with the green 1 key (with no 

UHF Pro marking), make sure that the Primary Remote 
Address shows 

 IR and that this address matches the 

number you entered in step 4.

• If you are using 6.0 remote with the blue 2 UHF Pro key, 

make sure that the Secondary Remote Address matches 
the number you entered in step 4.

8. Close the System Information screen. On most receivers, 

this is done by selecting the Done button. See your receiver 
user's guide for more information.

text_dishpvr.fm  Page 7  Tuesday, March 2, 2004  12:35 PM