Sony Corporation VGPUHDM08 用户手册
12
VGP-UHDM08_2-469-113-11(1)
Disconnecting the drive from the computer
Follow the procedure below to disconnect this drive from your computer.
(The following procedures are for Windows XP.)
(The following procedures are for Windows XP.)
Notes
• Before disconnecting the drive, close any open programs.
• If the message below appears when you attempt to disconnect the drive, close any
running software, wait for a while and then repeat the procedure.
“Problem Ejecting USB Mass Storage Device. The device ‘Generic Volume’ cannot be
stopped right now. Try stopping the device again later”.
stopped right now. Try stopping the device again later”.
z
Tip
To use the drive again after disconnecting the USB cable, perform the steps described in
the section “Getting Started” on page 8. The drive will be detected automatically by your
Windows operating system.
the section “Getting Started” on page 8. The drive will be detected automatically by your
Windows operating system.
The
icon appears on the taskbar when the drive is recognized by the
computer. To disconnect the drive from the computer, use the
icon.
1
Click the
icon on the taskbar.
The “Safely remove USB Mass Storage Device” message appears.
2
Click “Safely remove USB Mass Strorage Device”.
The message “The ‘USB Mass Storage Device’ can now be safely
removed from the system” appears.
removed from the system” appears.
3
Disconnect the USB cable.
01GB02C01_UHDM08.p65
05.8.1, 1:10 PM
12
Black