Kenwood USA Corporation 33293110 用户手册
7
I
NSTALLING
/ R
EMOVING
THE
B
ELT
H
OOK
1
Align the belt hook tabs with the guides on the rear of the
transceiver.
transceiver.
2
Slide the belt hook down the guides until it locks in place.
3
To remove the belt hook, pull back on the lever on the top
of the belt hook and slide the belt hook out of the guides.
of the belt hook and slide the belt hook out of the guides.
I
NSTALLING
/ R
EMOVING
O
PTIONAL
A
CCESSORIES
Note: Always switch OFF the transceiver power when installing or
removing the optional accessories.
removing the optional accessories.
The following accessories can be used with this transceiver:
•
SMC-34 Speaker-Microphone
•
HMC-3 Headset
•
EMC-3 Clip Microphone with Earphone
To install these accessories:
1
Open the MIC-SP tabs on the side of the transceiver.
2
Insert the accessory’s plugs into the MIC-SP jacks.
3
When you remove the accessory from the transceiver, be
sure to cover the MIC-SP jacks with the attached tabs in
order to keep dust and dirt away from the contacts.
sure to cover the MIC-SP jacks with the attached tabs in
order to keep dust and dirt away from the contacts.
Note:
◆
Refer to the accessory instruction manuals for detailed instruction
on each of the accessories.
on each of the accessories.
◆
The 3 programmable function keys on the SMC-34 cannot be used
with this transceiver. To use the speaker-microphone, press the
PTT switch to transmit and release it to receive. You can also
adjust the volume level using the SMC-34 Volume control.
with this transceiver. To use the speaker-microphone, press the
PTT switch to transmit and release it to receive. You can also
adjust the volume level using the SMC-34 Volume control.