Cisco 7200 Compact Flash Disk for NPE-G1, 128 MB Option MEM-NPE-G1-FLD128= 用户手册
产品代码
MEM-NPE-G1-FLD128=
1-4
Memory Replacement Instructions for the Network Processing Engine or Network Services Engine and Input/Output Controller
OL-8358-03
Chapter 1 CompactFlash Disk, Flash Disk, and Flash Memory Card Information
Installing and Removing a CompactFlash Disk, Flash Disk, or Flash Memory Card
Enter configuration mode and specify a filename and PC card slot from which to boot using the
configure terminal and boot system commands as follows:
configure terminal and boot system commands as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
System(config)# boot system flash disk0:c7200-p-mz.12-0
The result of this configuration file entry is that the BOOT variable is disk0:c7200-p-mz.12-0.
•
CONFIG_FILE (configuration file) variable—Determines where the configuration is read from on
bootup; you set it in configuration mode as follows:
bootup; you set it in configuration mode as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
System(config)# boot config disk0:configfile
The result of this configuration file entry is that the CONFIG_FILE variable is disk0:configfile.
•
BOOTLDR (boot loader) variable—Determines which image is used as the boot helper (boot
image); you set it in configuration mode as follows:
image); you set it in configuration mode as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
System(config)# boot bootldr bootflash:c7200-boot-mz
The result of this configuration file entry is that the BOOTLDR variable is
bootflash:c7200-boot-mz.
bootflash:c7200-boot-mz.
•
Configuration register variable—Instructs the system where to look for a bootable Cisco IOS
software image; you set it as a hexadecimal value in configuration mode as follows:
software image; you set it as a hexadecimal value in configuration mode as follows:
Router# configure terminal
Enter configuration commands, one per line. End with CTRL-Z.
System(config)# config-register 0x102
The result of this configuration file entry is that the configuration register is set to hexadecimal
0x102. For more information about the configuration register, see Chapter 4, “Observing System
Startup and Performing a Basic Configuration,” in the Cisco 7200 VXR Installation and
Configuration Guide at the following URL:
0x102. For more information about the configuration register, see Chapter 4, “Observing System
Startup and Performing a Basic Configuration,” in the Cisco 7200 VXR Installation and
Configuration Guide at the following URL:
Installing and Removing a CompactFlash Disk, Flash Disk, or
Flash Memory Card
Flash Memory Card
This section describes the proper method for installing and removing a CompactFlash Disk, Flash Disk,
or Flash memory card into the CompactFlash Disk slots on an NPE-G1 or NPE-G2, or the Flask Disk or
PC card slots on an I/O controller.
or Flash memory card into the CompactFlash Disk slots on an NPE-G1 or NPE-G2, or the Flask Disk or
PC card slots on an I/O controller.
Tip
All CompactFlash Disks, Flash Disks, and Flash memory cards must be formatted before their initial
use. CompactFlash Disks, Flash Disks, or Flash memory cards shipped with an I/O controller, NPE-G1,
or NPE-G2, are formatted at the factory, but spare memory cards are not formatted. To avoid potential
problems when using spare memory cards, we recommend that you reformat all of your memory cards
using the recommended minimum Cisco IOS software release for your platform during your regularly
scheduled service times. (See the
use. CompactFlash Disks, Flash Disks, or Flash memory cards shipped with an I/O controller, NPE-G1,
or NPE-G2, are formatted at the factory, but spare memory cards are not formatted. To avoid potential
problems when using spare memory cards, we recommend that you reformat all of your memory cards
using the recommended minimum Cisco IOS software release for your platform during your regularly
scheduled service times. (See the
.)