JVC KENWOOD Corporation K2T001 用户手册
31
(to the next page)
B. When card is at the left (near printing unit)
1.
Adjust the direction of the tilted card with your
hand such that it is parallel with the card guide.
hand such that it is parallel with the card guide.
2.
Turn the knob of the card transfer in the anti-
clockwise direction to transfer card to the
stacker.
clockwise direction to transfer card to the
stacker.
3.
Install the ink cassette and close the printer door.
Refer to pages 13 and 14 of this manual.
Printer will start to initialize and return to the Ready mode.
C. When card can barely be seen from the encoding unit
1.
Open the jog cover behind the card cassette, turn
the jog dial in the anti-clockwise (upward)
direction to move card into the encoder. Refer
to Feed Jam (page 29 of this manual) on how to
open the jog cover.
the jog dial in the anti-clockwise (upward)
direction to move card into the encoder. Refer
to Feed Jam (page 29 of this manual) on how to
open the jog cover.
2.
If the inverter is not vertical, turn it to a vertical
position with your hand.
position with your hand.
3.
Turn the jog dial clockwise (down) to move card
from the encoding unit to the inverter, followed
by removing it with your hand.
from the encoding unit to the inverter, followed
by removing it with your hand.
4.
Install the ink cassette and close the printer door.
Refer to pages 13 and 14 of this manual.
Refer to pages 13 and 14 of this manual.
Printer will start to initialize and return to the Ready
mode.
mode.
Jam Inside Laminator
Refer to the instruction manual of the laminating unit
on procedures to remove the jammed card.
on procedures to remove the jammed card.
Card Transfer Knob