Raytheon Anschuetz GmbH High Seas Products MTX5 用户手册
22
Pathfinder Radar Scanners
5. Using suitable lifting equipment, raise the pedestal over the mounting
surface. Carefully lower into position, taking care that the studs pass
through the holes without damaging the threads. Ensure that the cable inlet
is pointing aft.
through the holes without damaging the threads. Ensure that the cable inlet
is pointing aft.
WARNING
Support the pedestal unit until it has been secured to the mounting
platform. It is important that all four sets of nuts and washers are used to
secure the pedestal to the mounting platform.
Support the pedestal unit until it has been secured to the mounting
platform. It is important that all four sets of nuts and washers are used to
secure the pedestal to the mounting platform.
6. Referring to the following illustration, use the four nuts and associated
washers supplied to secure the pedestal.
Grease the nuts.
If required, cut-off any excess stud.
Grease the nuts.
If required, cut-off any excess stud.
Pedestal
25mm (1in)
Bitumen washer,
sticky side down
on platform
Bitumen washer,
sticky side down
on platform
Mounting
platform
platform
Lifting eye
M10 plain washer
M10 spring washer
M10 stud
length = 52 mm
plus platform depth
length = 52 mm
plus platform depth
M10 nut
D4573-1
154_2c2.p65
13/05/99, 13:18
22