Motorola Solutions Inc. 92FT7083 用户手册
ii
Installation Requirements for Compliance with
Radio Frequency (RF) Energy Exposure Safety
Standards
ATTENTION!
This radio is intended for use in occupational/controlled conditions, where users have full knowledge
of their exposure and can exercise control over their exposure to meet FCC limits. This radio device is
NOT authorized for general population, consumer, or any other use.
of their exposure and can exercise control over their exposure to meet FCC limits. This radio device is
NOT authorized for general population, consumer, or any other use.
To ensure compliance to RF Energy Safety Standards:
•
Install only Motorola approved antennas and accessories.
•
Be sure that antenna installation is per Antenna Installation on page 2-12 of this manual.
•
Be sure that Product Safety and RF Safety Booklet enclosed with this radio is available to the end user
upon completion of the installation of this radio.
Before using this product, the operator must be familiar with the RF energy awareness information and
operating instructions in the Product Safety and RF Exposure booklet enclosed with each radio (Motorola
publication part number 6881095C99_) to ensure compliance with Radio Frequency (RF) energy exposure
limits.
operating instructions in the Product Safety and RF Exposure booklet enclosed with each radio (Motorola
publication part number 6881095C99_) to ensure compliance with Radio Frequency (RF) energy exposure
limits.
This radio has a transmitter Time-out Timer that disables the transmitter during a transmission after a pre-
defined time period, which by default is set to 60 seconds.
defined time period, which by default is set to 60 seconds.
For a list of Motorola-approved antennas and other accessories, visit the following web site, which lists
approved accessories for your radio model:
approved accessories for your radio model:
http://www.motorolasolutions.com
For radios installed in vehicles fuelled by liquefied petroleum gas, refer to the (U.S.) National Fire
Protection Association standard, NFPA58, for storage, handling, and/or container information.
Protection Association standard, NFPA58, for storage, handling, and/or container information.
It is recommended NOT to change the default 60 seconds time period for the Time-out Timer as the
radio is intended for intermittent duty cycle operation.
radio is intended for intermittent duty cycle operation.
!
W A R N I N G
!
C a u t i o n