CYTEK Co. Ltd. CWT8037RX 用户手册

 

                                           

receiver PCB module uses 2.4 GHz wireless data transmission module one. 28 remote control 

buttons and a red status indicator, using two AAA batteries. Receiver PCB module is made in 

accordance with specific size requirements, the interface has a USB interface 

This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

 (1)   This device may not cause harmful interference, and 

 (2)   This device must accept any interference received, including interference that may cause 

undesired operation. 

NOTE: The manufacturer is not responsible for any radio or TV interference caused by 

unauthorized modifications to this equipment. Such modifications could void the user’s authority 

to operate the equipment. 

 

2．1

 Remote control and receiver connections. 

Power off the host, while holding the remote control Return and Option keys, the two AAA 

batteries into the remote control marked by positive and negative inside, LED flash, then release 

the button, the remote control is connected to the code. During this power on the host, the remote 

control receiver with this host connection. If successful the remote control to enter the work state, 

the LED stops flashing the remote control. 

Note: The code to connect to the remote control to enter the state, if not two minutes to complete 

the work on the code or press any key to connect, the exit status of the code. If you want to re-

enter the code to connect to the connection status of the code. 

Remote control and receiver connected to the code once, it will be one to one control, with no 

need to code after the operation. Unless the remote control to change the new terminal and re-

code new control side after. Will lose the original remote control side of the connection.

 

 

2．2

remote control and receiver PCB interface 

Remote control