HP HHI508FC 用户手册

WARNING!

Use of controls or adjustments or performance of procedures other than those specified 

herein or in the laser product’s installation guide may result in hazardous radiation exposure. To 

reduce the risk of exposure to hazardous radiation:

●

Do not try to open the module enclosure. There are no user-serviceable components inside.

●

Do not operate controls, make adjustments, or perform procedures to the laser device other than 

those specified herein.

●

Allow only HP Authorized Service technicians to repair the unit.

Power supply and power cord set requirements

Power supply class I grounding requirements

For protection from fault currents, the equipment shall be connected to a grounding terminal. Plug the 

system power cord into an AC outlet that provides a ground connection. Substitute cords may not 

provide adequate fault protection. Only use the power cord supplied with this product or a Hewlett-

Packard authorized replacement.

Brazil notice

Este equipamento deve ser conectado obrigatoriamente em tomada de rede de energia elétrica que 

possua aterramento (três pinos), conforme a norma nbr abnt 5410,visando a segurança dos usuários 

contra choques elétricos.

Denmark

Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver forbindelse til stikproppens jord.

Finland

Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.

Norway

Apparatet må tilkoples jordet stikkontakt.

Sweden

Apparaten skall anslutas till jordat uttag.

Power supply requirements

The power supplies on some products have external power switches. The voltage select switch 

feature on the product permits it to operate from any line voltage between 100-127 or 200-240 volts 

AC. Power supplies on those products that do not have external power switches are equipped with 

internal circuits that sense the incoming voltage and automatically switch to the proper voltage.
For safety reasons, use only the AC adapter provided with the unit or an authorized replacement 

adapter from Hewlett-Packard. Replacement part numbers may be found at 

For use in Norway

This product is also designed for an IT power system with phase-to-phase voltage 230V.

Power supply and power cord set requirements 27