Andrew Wireless Innovations Group RPT-NODEC843 用户手册

4 Commissioning 

 

ID No: 161692 

PRELIMINARY 

Page 63

 

 
c)  Notes on the AAA Measurement Results: 
 
1.  The DL RX Power is the total power in the selected 5 MHz channel. The DL Rx 

Power measurement is updated approximately once per second.   

2. The Pilot Received Signal Code Power (RSCP) measurements are updated 

approximately once every four seconds after the antenna assistant finds a valid 
pilot channel within the selected 5MHz bandwidth. It may take up to one minute to 
perform the initial scan and report Pilot RSCP results. 

3.  The most recent results are displayed in the first row, and previous results move 

down one row in the table. 

4.  Data is columnized based on the most recent pilot measurement results. 
5.  The pilot measurements display up to the four strongest rays. The measurement 

result could show one pilot with four rays, two pilots with two rays each, one pilot 
with three rays and one pilot with one ray, or four pilots with one ray each (or 
fewest results if no additional pilots are found). 

6.  Multiple rays of the same pilot will be shown if the weaker rays are within 10dB of 

the strongest ray.  

7.  The Pilot RSCP data is sorted based on the total power of all multipaths for each 

particular scramble code. For instance, if one pilot has two rays, each at –63dBm 
(for a total power of -60 dBm), they will be listed first if all other pilots are less than 
-60 dBm. 

8.  If two or more multipath signals are received, then the power of each ray will be 

displayed in order of arrival. The first ray is the line of sight signal and should be 
the strongest. However, it is possible for the later rays to be stronger. 

 

 
This page serves to 
upload new software 
(press the Upload 
Software button and 
follow the instructions) 
and for entering the 
modem settings for 
OMC communication.