Celestron NexStar 130SLT 31145 用户手册
产品代码
31145
Quick Set-up Guide [cont]
Secure optical tube to fork arm by
tightening the screw located on the
inside of the fork arm assembly.
tightening the screw located on the
inside of the fork arm assembly.
11
To attach the finderscope, loosen the silver
screw and slide finderscope into mounting
platform .
screw and slide finderscope into mounting
platform .
12
Secure finderscope to mounting platform by
tightening the silver screw. The glass window of
the finderscope should be facing towards the
front of the telescope.
tightening the silver screw. The glass window of
the finderscope should be facing towards the
front of the telescope.
13
Select the low power (25mm) eyepiece
and insert it as shown above.
and insert it as shown above.
14
Tighten silver screw to secure.
15
Attach plastic hand control holder to the
tripod leg.
tripod leg.
16
Slide Computerized Hand Control into
the hand control holder as shown above.
the hand control holder as shown above.
17
18
Before you begin viewing, please
remember to remove tube lens cap.
remember to remove tube lens cap.
19
While observing, tube should be
positioned as shown above.
positioned as shown above.
10
Plug Computerized Hand Control into
the “Hand Control” port on the fork arm.
the “Hand Control” port on the fork arm.
Before you can begin observing, you must setup your hand control,
align your finderscope and align your telescope. Step by step
instructions are included in the following Hand Control Setup section.
20
Before you can use your telescope, you
must insert 8 AA batteries.
must insert 8 AA batteries.
21
Place AA batteries inside the battery
compartment located at the base of the
fork arm.
compartment located at the base of the
fork arm.