Biolog-id SSTABIOLOGID 用户手册
Smart Storage Agitator User Manual
Version: 1.0
Validation date of the manual: 18/09/2018
25 of 27
Red LED calculator
Possible causes
Action
Loss of communication on the CAN bus
Switch to maintenance mode and reboot the
calculator
calculator
CAN bus power shorted
Switch to maintenance mode and reboot the
calculator
calculator
Calculator probe disconnected from the RFID
card
card
Connect the temperature probe
Ethernet network disconnected
Disconnect and connect the Ethernet cable
Insufficient SD Card memory space
Verify that a notification has been sent to the
third-party system. Contact the administrator.
third-party system. Contact the administrator.
Power failure of at least one drawer
Verify that a notification has been sent to the
third-party system. Contact the administrator.
third-party system. Contact the administrator.
Battery charger Failure
Verify that a notification has been sent to the
third-party system. Contact the administrator.
third-party system. Contact the administrator.
Contact
the
supplier
of
your
device
in
case
of
malfunction.
Do not repair or modify the device without prior authorization from Biolog-Id.
Any maintenance operation must be preceded by an SST-A mode change to enter
maintenance mode (see GUI Manual).
Any maintenance operation must be preceded by an SST-A mode change to enter
maintenance mode (see GUI Manual).
7. Warranty
Any non-compliance with the recommendations will result in a breach of the warranty.
8. Transport
Upon receipt of the SST-A, check that it has not been damaged during transport.
If you notice any transport damage, immediately contact the carrier or your dealer with the
delivery
If you notice any transport damage, immediately contact the carrier or your dealer with the
delivery
note
or
the
purchase
order.
Packaging example:
SST-A Kit set
RFID Card pack
Calculator pack