Mobilaris AB 466C 用户手册
Mobilaris Equipment Tag
Rugged tag for fixed installation in vehicles and equipment with 12/24 volt power supply.
DESCRIPTION
The tag is embedded in a protective case to allow discrete mounting in vehicles and equipment. It communicates
with Mobilaris Mining Intelligence to provide location as well as other types of sensor data.
The 2-colored LED indicates the following:
Operational status:
Green = CCX communication ongoing
Red and green = Connecting to access point
Power-on Self-test:
Blinks
with Mobilaris Mining Intelligence to provide location as well as other types of sensor data.
The 2-colored LED indicates the following:
Operational status:
Green = CCX communication ongoing
Red and green = Connecting to access point
Power-on Self-test:
Blinks
Green
Red
1st Power supply
OK
Low input power
2nd Magnetic field noise level
OK
High interference
3rd Error
OK
Broken tag
4th System failure
OK
Configuration problem
MOUNTING INSTRUCTIONS
The tag should either be screwed or mounted using adhesive pads on the dashboard or windshield.
The tag must be clearly visible through the windshield.
The tag must be clearly visible through the windshield.
Consider the following during mounting
:
•
Maximum Torque, 1 lb ft / 1.5 Nm
• Screw, ø 1/8” - 5/32” / 3-4 mm
• Do not tighten too hard - the tag should not bend
• Do not tighten too hard - the tag should not bend
• Do not place the tag too close to other electrical applicances that generates magnetic fields (See self-test
2)
Avoid mou
nting the tag closer than 1 3/16 ″ (30 mm) to metal surfaces since it may reduce the range of the WiFi
radio and Exciter detection.