SHENZHEN G-KINDLY ELECTRONIC CO. LTD KDL-BT1811 用户手册

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two conditions: (1) this 

device may not cause harmful interference, and (2) this 

device must accept any interference received; including 

interference that may cause undesired operation.
Federal Communications Commission (FCC) Statement

This Equipment has been tested and found to comply with 

the limits for a Class B digital device, pursuant to Part 15 

of the FCC rules. These limits are designed to provide 

reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses 

and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, 

There is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause 

harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, 

the user is encouraged to try to correct the interference by 

one or more of the following measures:

・  Reorient or relocate the receiving antenna.

・  Increase the separation between the equipment and 

receiver.

・  Connect the equipment into an outlet on a circuit 

different from that to which the receiver is connected.

・  Consult the dealer or an experienced radio/TV/

technician for help.

expressly approved by the party responsible for 

compliance could void the user authority to operate the 

equipment.Tested to comply with FCC standard.

FOR HOME OR OFFICE USE.
Warning:
This equipment complies with FCC RF radiation exposure 

limits set forth for an uncontrolled environment. This 

device and its antenna(s) must not be co-located or 

conjunction with any other antenna or transmitter.

Battery Information
Your Speaker is powered by a rechargeable battery. The 

full performance of new batteries is achieved only after two 

to three complete charge and discharge cycles. The 

battery can be charged and discharged hundreds of times, 

but it will eventually wear out. 

・ Do not leave a fully charged Speaker connected to a 

charger, overcharging may shorten its lifetime. If left 

unused, a fully charged Speaker battery will lose its 

charge over time.

・ Never use any charger that is damaged.
・ Leaving the device in hot or cold places will reduce the 

capacity and lifetime of the batteries. Optimal 

temperature for the batteries is between        and        . 

A device with a hot or cold batteries may not work 

temporarily, even when the batteries are fully charged.

・ 

Batteries may also explode if damaged. Always dispose 

of batteries according to local regulations. Please 

recycle. Do not dispose as household waste.

techsupport@esicellular.com or call (212) 883-8838

 2018 Billboard IP Holdings, LLC. All rights reserved. 

Billboard      ,the Billboard logo, HOT 100 and associated 

characters,trademarks and design elements are owned

and licensed by Billboard IP Holdings, LLC.
Bluetooth is a registered trademark of Bluetooth SIG
All other trademarks are property of their respective companies.

Introduction
Thank you for purchasing the Billboard Bluetooth 

Speaker. For best use of this device we recommend 

carefully reading this user manual and keeping it for 

your records

Package Contents
a. Bluetooth Speaker

b. USB charging cable

c. Instruction manual

d. AUX 3.5 mm cable

・ Your Bluetooth Speaker has an internal rechargeable 

battery.  Improper usage may result in the Speaker 

becoming hot, igniting or bursting and causing injury

if exposed to conditions of abuse.

・ Do not disassemble, throw away or damage the

Bluetooth Speaker.

・ Store the Bluetooth Speaker in a dry place, keeping 

it away from damp corrosive materials and 

environments such as salt air.

・ Keep the Wireless Speaker away from direct sunlight, 

Bluetooth Speaker inside a car during hot weather. 

Remember a closed car acts as a green house allowing 

the inside to reach high temperatures.

・ The Bluetooth Speaker is not a toy.  Please keep 

it out of the reach of young children.

・ Please do not discard the Wireless Speaker. 

Consult your local waste collection agency

for proper disposal or recycling methods.

You may also contact "Call2Recycle"

at 877-273-2925 or online at

"call2recycle.org" for a battery

recycling drop off location near you.

Charging The Battery
1. Plug the charger cable into the charge port.

2. Connect the charger to a USB power source. The red 

indicator light will display during charging. If charging 

does not start, disconnect the charger plug it in again, 

and retry. Charging the battery fully may take hours.

3. When the battery is fully charged, the red indicator light 

will turn off. Disconnect the charger from the USB 

power source and the Speaker. The fully charged 

battery has power for hours of music time.

Limited Warranty
   

purchaser that this product, when shipped in its original container to 

the original purchaser, will be free from defective workmanship and 

materials for one year and agrees that it will, at its option, either 

repair the defect or replace the defective product or part thereof at 

no charge to the purchaser for parts or labor for the time periods 

described.
  This warranty does not apply to any appearance items of the 

product nor to the additional excluded item(s) set forth below nor to 

any product the exterior of which has been damaged or defaced 

which has been subjected to misuse, abnormal service or handling 
limited warranty described herein is in addition to an applicable law. 
ALL IMPLIED WARRANTIES INCLUDING THE WARRANTIES OF 

MERCHANTABILITY AND FITNESS FOR USE ARE LIMITED TO THE 

PERIOD FROM THE DATE OF ORIGINAL PURCHASE SET FORTH 

BELOW. Some states do not allow limitations on how long an implied 

warranty last, so the above limitation may not apply to you. Neither 

the sales personnel of the seller nor any other person is authorized to 

make any warranties other than those described herein or to extend 

the duration of any warranties beyond the time period described 

herein on the behalf of ESI Cases and Accessories. 

  The warranties described herein shall be the sole and exclusive 

warranties granted by ESI Cases and Accessories and shall be the 

sole and exclusive remedy available to the purchaser corrections of 

defects, in the manner and for the period of time described herein, 
of ESI Cases and Accessories to the purchaser with respect to the

product and shall constitute full satisfaction of all claims, whether

based on contract negligence, strict liability or otherwise. In no

event shall ESI Cases and Accessories be liable or in any way 

responsible, for any incidental of consequential economic or 

property damage. Some states do not allow the exclusion of 

incidental or consequential damages, so the above exclusion may 

not apply to you. THIS WARRANTY GIVES YOU SPECIFIC LEGAL 
RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS, WHICH VARY 

FROM STATE TO STATE.
  This warranty does not cover cables that have become frayed, 

cracked, or broken from use. The user should immediately replace 

this, or any, charge cable that has become frayed, cracked, or 

broken, as it may constitute a serious safety risk, including 

electrocution, if it is continued to be used.

ESI Cases and Accessories

*Enclose proof of purchase and $11.95 for Shipping and Handling.

d.

c.

a.

Pairing The Speaker
1. Press ON/OFF button to power on. The indicator LED will 

 light and indicate it is ready to pair.

2. Activate the Bluetooth  feature on your device, and set 

the device to discovery mode to search for wireless 

audio devices. (See the User Manual for your device)

3. Tap the Speaker on your device displayed as BB-BT-SP.

(if pass code is requested enter 0000)

*  Once the Speaker has been paired, it will automatically 

connect with your device.

BLUETOOTH SPEAKER

shall constitute complete fulfillment of all liabilities and responsibilities

Model: BB290, KDL-BT1811