Xiamen Four-Faith Communication Technology Co. Ltd. F8L10D-N 用户手册
F8L10D-N LoRa Module User Manual
Page 24 of 33
Add：11th Floor, A-06 Area, No.370, Chengyi Street, Jimei, Xiamen, Fujian, China.
the data transfer data speed.
Note: The Bit Rate should keep the same value, while transferring data between two
module.
The default is 3.
4.3.6 Radio Frequency
The module without PA can set the radio frequency from 5dBm to 20dBm. But the
ones with PA is fixed to 30dBm.
Default value: 20
4.3.7 Relay Address
The relay address will be adopted when the transmission distance between nodes
is too long. This parameter is set as the ID of the relay node, and the relay node will help
transmit the data to the final destination node.
Default value:1000
4.3.8 Sleep Mode
The module work on different power mode, such as None,Time and Deep.
None sleep mode -- Max power consumption on
Time sleep mode -- wake up the module by RTC timer.
Deep sleep mode -- wake up the module by RST or SLEEP_RQ pin.
When Sleep mode is Time, the Wake-up Time and Sleep Time Must Set.
Default value is None.
When the sleep is set Time Mode, the Wake-up Time is the duration of the module
keep activity. The unit is millisecond.
When the sleep is set “Time” Mode, the “Sleep Time” is the duration of the module
keep inactivity. The unit is millisecond.
4.3.9 Debug Level
Debug information is used to debug software when there is software problem. As
showing in the figure 4-3
0 --- no debug information output
1 --- simple prompt information output