Troll Systems Corporation SLLBTX646501 用户手册

下载
页码 38
User Manual
6.5 GHz RF Linkbox for Tracking Antenna - Troll Systems Corporation 
6
 Document 200610D - 7/11/17 
2.1.1
Know and Comply with Local, State, and Federal Safety Requirements
All personnel handling and using this equipment should be familiar with all local, state, 
and federal safety requirements applicable to the equipment, processes, and materials 
you use during maintenance. Before using any substances or materials marked toxic or 
hazardous, always refer to the Material Safety Data Sheets (MSDS) for that substance/
material for any special protective equipment, handling, and/or disposal requirements.
2.1.2
Do Not Service or Adjust Alone
Do not start a maintenance or adjustment procedure if that procedure requires more than 
one technician to be safely performed. It is particularly important that such work not be 
performed in a remote area away from other qualified personnel who may be needed to 
render assistance. When a maintenance task requires two or more personnel to be safely 
accomplished, delay the task until qualified personnel are available to assist you.
2.2
RF SAFETY CONSIDERATIONS AND PRECAUTIONS
The guidelines for safe operation herein are derived from OET bulletin 65, August 1997, 
as recommended by the Federal Communications Commission (FCC).
When this system is operated without an antenna, it will not create RF energy exceeding 
1.0 mW/cm
2
,
 
which is the FCC limit for exposure. Connecting an antenna to the unit 
greatly increases the potential for harmful exposure to microwave radiation and all 
personnel must maintain a minimum distance from the radiator per the amount of 
radiation emanating from the transmitter and the antenna.
CAUTION:
Any modifications made to the LinkBox not approved by 
Troll Systems Corporation will void the user’s authority to 
operate this equipment.
WARNING:
High levels of RF power are present in the unit. Exposure 
to RF or microwave power can cause burns and may be 
harmful to health. Remove power from the unit prior to 
disconnecting any RF cables and before inspecting 
damaged cables and/or antennas. Avoid standing in front 
of high gain antennas (such as a dish antenna) and never 
look into the open end of a waveguide or cable where RF 
power may be present.