Shenzhen Feasycom Technology Co. Ltd FSC-BT909 用户手册

 

 

 

Integrator is reminded to assure that these installation instructions 

will not be made available to the end

-

user of the final host device.

 

The final host device, into which this RF Module isintegrated" hasto be labelled 
with an auxilliary lable stating the FCC IDofthe RF Module, 

such as "Contains FCC ID: 

 2AMWOFSC-BT909 

 
"This device complies with part 15 of the FCC rules. Operation is subject to the following two 
conditions: 
(1)this devicemay not cause harmful interference, and 
(2)this devicemust accept any interference received, including 
interference thatmay cause undesired operation." 

 
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital 
device,  pursuant  to  part  15  of  the  FCC  Rules.  These  limits  are  designed  to  provide  reasonable 
protection 
against harmful interference in a residential installation. This equipment generates, uses and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may  cause  harmful  interference  to  radio  communications.  However,  there  is  no  guarantee  that 
interference  will  not  occur  in  a  particular  installation.  If  this  equipment  does  cause  harmful 
interference to radio or television reception, which can be determined by turning the equipment 
off  and  on,  the  user  is  encouraged  to  try  to  correct  the  interference  by  one  or  more  of  the 
following measures: 
--Reorient or relocate the receiving antenna. 
--Increase the separation between the equipment and receiver. 
--Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 
--Consult the dealer or an experienced radio/TV technician for help. 
 
Changes or modifications to this unit not expressly approved by the party responsible for 
compliance could void the user's authority to operate the equipment. 

(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated RF Module. 
For 15 B (§15.107 and if applicable §15.107) compliance, the host manufacturer is required to 
show compliance with 15 while the module is installed and operating.
 
Furthermore the module should be transmitting and the evaluation should confirm that the module's
intentional emissions (15C) are compliant (fundamental / out-of-band). Finally the integrator has 
to apply the appropriate equipment authorization (e.g. Verification) for the new host device per 
definition in §15.101.