Eko Devices Inc. E5 用户手册
P.
4
1.5
Skin Preparation
Excessive hair, dirty skin, dry skin, or oily skin can
impact the quality of the ECG tracing. Clean the
patient's skin with water and soap and remove excess
hair as needed to achieve the highest quality tracing.
Do not use the DUO over wound areas or areas of
broken skin. Do not use an alcohol based skin cleaner
as this dries out the patient's skin and increases
resistance. Dry the skin vigorously to increase capillary
blood flow to the tissues.
impact the quality of the ECG tracing. Clean the
patient's skin with water and soap and remove excess
hair as needed to achieve the highest quality tracing.
Do not use the DUO over wound areas or areas of
broken skin. Do not use an alcohol based skin cleaner
as this dries out the patient's skin and increases
resistance. Dry the skin vigorously to increase capillary
blood flow to the tissues.
ECG gels or saline solutions can be used on the
electrodes to improve signal quality.
electrodes to improve signal quality.
FCC Intentional Radiator Certi ication
FCC ID: 2ANB3-E5
IC:23063-E5
IC:23063-E5
This equipment contains an intentional radiator
approved by the FCC under the FCC ID numbers
shown above. This device complies with Part 15 of
the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesirable operation.
approved by the FCC under the FCC ID numbers
shown above. This device complies with Part 15 of
the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may
cause undesirable operation.
NO MODIFICATION: Modifications to this device
shall not be made without the written consent of Eko
Devices, Inc. Unauthorized modifications may void
the authority granted under Federal Communications
Commission rules permitting the operation of this
device.
shall not be made without the written consent of Eko
Devices, Inc. Unauthorized modifications may void
the authority granted under Federal Communications
Commission rules permitting the operation of this
device.
EMC Compliance Europe
This equipment complies with the EMC requirements
of the IEC 60601-1-2.
This equipment complies with the EMC requirements
of the IEC 60601-1-2.
1.6
EMC Compliance
To ensure a proper ECG and PCG recording, clean the
electrodes with an alcohol-based cleaning solution
prior to use.
electrodes with an alcohol-based cleaning solution
prior to use.
Cleaning and Disinfecting Procedure
The device and earpieces should be cleaned between
each patient use. All cleaning instructions pertaining
to stethoscopes and ECG units in general apply.
The device and earpieces should be cleaned between
each patient use. All cleaning instructions pertaining
to stethoscopes and ECG units in general apply.
Under normal conditions it is unnecessary to separate
the device from the earpieces for cleaning. All external
parts of the hardware can be cleaned with 70%
isopropyl alcohol wipes.
the device from the earpieces for cleaning. All external
parts of the hardware can be cleaned with 70%
isopropyl alcohol wipes.
NOTE: DO NOT immerse the device in any liquid or
subject it to any high-pressure/autoclave sterilization
processes.
subject it to any high-pressure/autoclave sterilization
processes.
1.7
Cleaning
RSS-GEN, Sec. 7.1.3
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
Le pr sent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autoris e aux deux conditions suivantes : (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radio lectrique subi, m me si le brouillage est
susceptible d’en compromettre le fonctionnement.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate
thisequipment.
Attention: Les changements ou modifications de cet appareil non
express ment approuv par le fabricant peuvent annuler votre droit
utiliser cet quipement.