RosimITS Tech.CO. Ltd. WVD 用户手册
User Manual: Wireless Vehicle Detector
7 / 9
6.1. Preparations
It should be known that the Wireless Access Point is required to be installed prior to
WVDs, considering the WVD’s online status needs to be verified under the network
established by them when installing.
Before installing, a band tape, a drill, a hammer, a chisel and a set of screw drivers
should be prepared.
WVDs, considering the WVD’s online status needs to be verified under the network
established by them when installing.
Before installing, a band tape, a drill, a hammer, a chisel and a set of screw drivers
should be prepared.
6.2. Installation steps
Step 1: Sensor ID
Find the ID signed on the top of the WVD, allocate
the ID to a certain lane according to the project
schematic, and remember the arrangement to make
sure which sensor will be installed in which lane.
Note that in a certain project, every ID of all the
sensors is unique, so the corresponding relationship
between a sensor and the lane where the sensor
installed is also unique.
the ID to a certain lane according to the project
schematic, and remember the arrangement to make
sure which sensor will be installed in which lane.
Note that in a certain project, every ID of all the
sensors is unique, so the corresponding relationship
between a sensor and the lane where the sensor
installed is also unique.
Step 2: Measurement
Measure and find the centre of the lane. The position
along with the lane is defined according to the
application.
Note that a simple way to define the installation
position for WVDs is just select the right place where
a traditional loop detector was ready to install.
along with the lane is defined according to the
application.
Note that a simple way to define the installation
position for WVDs is just select the right place where
a traditional loop detector was ready to install.