KZ Broadband Technologies Ltd. AM4000MHGW 用户手册

Page 2 

 

 

The radio equipment described in this guide uses radio frequency transmitters. Although 

the power level is low, the concentrated energy from a directional antenna may pose a 

health hazard. Do not allow people to come in close proximity to the front of the antenna 

while the transmitter is operating. 

Before connecting this instrument to the power line, make sure that the voltage of the power source 
matches the requirements of the instrument. The unit must be standards. 

Pursuant to the WEEE EU Directive electronic and electrical waste must not be disposed of 

with unsorted waste. Please contact your local recycling authority for disposal of this 

product.

 

This CPE is compliant with the EU Registration, Evaluation, Authorization and Restriction 

of Chemicals (REACH) Regulation (Regulation No 1907/2006/EC of the European 

Parliament and of the Council) and the EU Restriction of Hazardous Substances (RoHS) 

Directive (Directive 2002/95/EC of the European Parliament and of the Council)

. 

 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 
(1) This device may not cause harmful interference, and (2) this device must accept any interference 
received, including interference that may cause undesired operation. 
 
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates, uses 
and can radiate radio frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. However, there is no guarantee 
that interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following 
measures: 
- Reorient or relocate the receiving antenna. 
- Increase the separation between the equipment and receiver. 
-Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

-Consult the dealer or an experienced radio/TV technician for help. 
 
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible 

for compliance could void the user's authority to operate the equipment. 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 

environment. This equipment should be installed and operated with minimum distance 20cm between 

the radiator & your body.