Bogen RPK88 产品宣传页
© 2005 Bogen Communications, Inc.
All rights reserved.
Specifications subject to change without notice.
54-2146-01E 1108
RPK88 Rack Mount Kit
Installation and Use Manual
The RPK88 Rack Mount Kit is designed to flush mount the modules of a PCM system. The RPK88 will hold up to
ten modules in two assemblies. The RPK88 allows easy mounting of these modules in a standard 19-inch audio
rack (the RPK88 is six rack spaces high). The kit includes twelve wiring saddles, eight mounting brackets, and eight
#6 x 1/4” screws
ten modules in two assemblies. The RPK88 allows easy mounting of these modules in a standard 19-inch audio
rack (the RPK88 is six rack spaces high). The kit includes twelve wiring saddles, eight mounting brackets, and eight
#6 x 1/4” screws
.
RPK88 Mounting Plate
Mounting
Brackets (8)
Wiring
Saddles (12)
Knock-out panels (nine total)
START HERE
(Panel left open)
Knock-out panel for power supply
power cord (as needed, two total)
power cord (as needed, two total)
Knock-out panels for wiring
access (as needed, six total)
Remove additional panels to fit
assembled module(s) (beginning
here, then work left to right)
Plug wiring saddles into any of
12 staggered holes as needed
Remove appropriate knock-
out panels.
out panels.
Six
Modules
Max.
Four
Modules
Max.
#6 x 1/4”
Screws (8)
3
3
2
2
1
1
2
3
Attach mounting brackets to
top and bottom corners of
module assembly.
Use screws included with
modules.
top and bottom corners of
module assembly.
Use screws included with
modules.
Attach module assembly
to RPK88 using #6 x 1/4”
screws.
to RPK88 using #6 x 1/4”
screws.
See PCM system instructions
for module assembly.
for module assembly.