RM Acquisition LLC 1000CA 用户手册

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 

two conditions: 

(1) this device may not cause harmful interference, and 

(2) this device must accept any interference received, including interference that may cause 

undesired operation.

FCC Statement 
This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in 

a particular installation. If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the equipment off and on, the 

user is encouraged to try to correct the interference by one or more of the following 

measures: 

—Reorient or relocate the receiving antenna. 

—Increase the separation between the equipment and receiver. 

—Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected. 

—Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement 
This device complies with FCC SAR exposure limits set forth for an uncontrolled 

environment. 

SAR compliance for using the equipment in close proximity to the human body has been 

evaluated at 0mm.

This equipment must not be co-located or operating in conjunction with any other antenna 

or transmitter. 

End-users and installers must be provide with antenna installation instructions and consider 

removing the no-collocation statement. 
Caution! 
Any changes or modifications not expressly approved by the party responsible for 

compliance could void the user's authority to operate the equipment.

 

 

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the 

following two conditions: 

(1) This device may not cause interference; and 

(2) This device must accept any interference, including interference that may cause 

undesired operation of the device.

 

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils 

radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 

(1) l’appareil ne doit pas produire de brouillage; 

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le 

brouillage est susceptible d’en compromettre le fonctionnement.

 

This equipment should be installed and operated with a minimum distance of 0mm 

between the radiator and your body.

 

Cet équipement devrait être installé et actionné avec une distance minimum de 0mm entre 

le radiateur et votre corps.

 

This transmitter must not be co-located or operating in conjunction with any other antenna 

or transmitter. 

Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu'aucune 

autre antenne ou émetteur.