Whirlpool Corporation XPSG 用户手册
CONNECTED APPLIANCE INFORMATION
OEM Responsibilities to comply with FCC and Industry Canada Regulations
The XPSG
The XPSG
Module has been certified for integration into products only by OEM
integrators under the following conditions:
1. The antenna(s) must be installed such that a minimum separation distance of 20cm is
maintained between the radiator (antenna) and all persons at all times.
2. The transmitter module must not be co-located or operating in conjunction with any
other antenna or transmitter.
As long as the two conditions above are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed (for example, digital device
emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain
configurations or co-location with another transmitter), then the FCC and Industry Canada
authorizations are no longer considered valid and the FCC ID and IC Certification Number
cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a
responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC and Industry Canada authorization.
End Product Labeling
The XPSG Module is labeled with its own FCC ID and IC Certification Number. If the FCC ID
and IC Certification Number are not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. In that case, the final end product must be labeled in a visible
referring to the enclosed module. In that case, the final end product must be labeled in a visible
area with the following:
“Contains Transmitter Module FCC ID: A5UXPSG”
“Contains Transmitter Module IC: 10248A-XPSG”
or
“Contains FCC ID: A5UXPSG”
“Contains IC: 10248A-XPSG”
The OEM of the XPSG
Module must only use the approved antenna(s), which have been
certified with this module. The OEM integrator has to be aware not to provide information to
the end user regarding how to install or remove this RF module or change RF related
parameters in the user manual of the end product.
The user manual for the end product must include the following information in a
prominent location:
“To comply with FCC and Industry Canada RF radiation exposure limits for general population,
the antenna(s) used for this transmitter must be installed such that a minimum separation
distance of 20cm is maintained between the radiator (antenna) and all persons at all times and
must not be co-located or operating in conjunction with any other antenna or transmitter.”