NINGBO FOREVER ELECTRONIC APPLIANCE CO. LTD. AMAS-2618 用户手册
5. Memory value: press Memory button afte r choosing the wanted mattress, LCD
shows Memory and starts inflating or deflating, once it gets th e memory data it will
stop(reset 25mbar, cut the power of RC it returns to the reset data)
6. Memory save: Press Memory button for 3s in the data showing state when the RC
flashes or stops working, LCD shows “Memory” and flas h to “Save”, d ata will be
memorized and saved as a new one. Use the same method to another.
五、Pay attention:
1.This RC can control 5 to 10 meters, it shows“ Er” when out of the distance, please use
it in its range.
2. Restart the remote co ntrol coding: This remote control and pump ar e coded be fore
leaving the factory, when RC needs a replacem ent that requires use r to calib rate the
code. Method as follows: Connect the pow er and during the 30s w hen light shows red,
please press any button the RC lighted. Next st ep is pres s Memory button first then
press L/R button for 3S, and LCD will show SU, it means coded successfully.
3. Two AAA-LR03-1.5V batteries are fitted for this RC; LCD will show the signal of i ts
low power and please change the batteries in time to avoid damage. Without any using in
the long time please remove out the batteries.
FCC Statement:
This equipment has been tested and found to comply with the lim its for Part 15 of the
FCC rules. These lim its are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.