NEC Corporation of America KMP6J1J1 用户手册
2
Inserting a SIM card
☛
Press the edge of the Rear cover in the direction of arrow
➀, then slide the rear cover in the direction of arrow ➁. Finally, lift the cover up in the
direction of arrow
➂ to remove it.
☛
Lift the knobs of the battery pack up in the direction of arrow
➃. Then slide the battery pack out in the direction of arrow ➄.
☛
Insert the SIM card sliding it under the holders of the both sides. Slide the SIM card until it locks.
,
If the SIM card is not fully inserted when the battery is replaced, damage to the SIM card can occur.
,
Do not scratch the holders of the both sides when inserting or removing a SIM card.
2
If the SIM card is already fitted, see “Start-up” on page 3.
Removing a SIM card
☛
With the battery removed, remove the SIM card sliding it lightly.
Charging the battery
Before trying to use your phone, insert the phone’s battery, connect the NEC battery charger (AC adapter) supplied
with your phone to a suitable mains power socket and then connect the charger’s output to the phone’s charger
connector.
☛
Connect the charger plug (AC adapter) into the connector at the side of the phone. Check that the Backlight
illumination is in colour 9 (Apple). When charging is completed, the Backlight illumination goes out.
You are recommended to switch off the phone during charging. If you need to receive calls, your phone can
You are recommended to switch off the phone during charging. If you need to receive calls, your phone can
be switched on and left in standby while being charged, although the total time taken to charge is then
increased.
Rear cover
Finger tab
Battery
Holder
SIM card
Backlight illumination
Charger connector