NEC Corporation of America KMP6J1N1 用户手册

下载
页码 140
Preparing the Battery
The performance of the 700 mAh, standard Lithium battery is: up to 150 hours standby time and 5 hours talk time is possible (3.5 hours
talk time is typical). These times are estimates only and depend on your location within the network, the frequency at which your
location is updated, the type of SIM you have, your reception area or ‘cell broadcast’ messages, and the use of Full Rate or Enhanced
Full Rate speech, as well as other factors that affect both standby and talk times.
Charging the Battery the First Time
Your phone is powered by a rechargeable battery. A new phone battery must be fully charged before using your wireless phone the first
time.
*
Before trying to use your phone, ensure the SIM card is inserted and the battery is in place on the phone. Place the battery
terminal end towards the hinge of the phone. Lower the battery toward the phone to lock into place. (See Warning and graphic in
right column.).
Connect the NEC battery charger supplied with your phone to a compatible power outlet.
Connect the charger plug into the connector on the base side of the phone. (See graphic in right column.)
Check for the battery charging icon in the status bar and that the second display backlight, located on the back of the flip cover,
glows red. (See Flag and graphic in right column.) To fully charge the battery, leave the phone charging until the second display
backlight goes out and the battery icon displays as full.
Checking the Battery
The battery charge indicator shows the approximate charge level of the battery while the phone is in use and not being charged. The
blocks on the display show the charge of your battery pack. The empty battery icon displays when the battery is nearly empty with
approximately one minute of talk time remaining.
Full battery power
Low battery power
Battery empty (red)
*
Check the icon at the top, left corner of the screen (the status bar, see page 7).
Low Battery Indication
If battery is completely discharged or brand new, there could be a few minutes delay before the second LCD display illuminates to
indicate charging. This is not an abnormal occurrence.
When the battery voltage falls below the working level, RECHARGE BATTERY appears on the main display area and an empty battery
icon displays in the status bar. With the recharge notification, the phone also sounds a short tone at ten-second intervals. Once the
recharge message displays and the short tone sounds, the phone battery has approximately one minute of use remaining. The phone
automatically powers Off.
The battery charge continues to drop after the “RECHARGE BATTERY” warning displays. In extreme cases where the battery is left
uncharged for some considerable time after the warning is displayed, a trickle charge is used to slowly charge the battery back up to a
safe level at which fast charging can begin. During this time, the battery icon will show charging but you are not able to make or receive
a call, or fully power On the phone. Normal wireless phone operation resumes once fast charging begins. The phone can be in trickle
charge 
for a few hours before fast charging starts if the battery is left uncharged for some days after the recharge warning.
I
DO NOT connect a charger or
any other external DC source if
the phone's battery is not
inserted. If this happens, the
phone may not function
properly.
O
The second display backlight
located on the back of the flip
indicates when charging is
complete by turning Off.
19